Zapp Automation for stepper motors. But consider if you really need to replace them – I built new driver electronics for a Denford Novamill using the bog standard 2M542 drivers and keeping the original motors. There's no sign that it's short of torque on the axis drives.

I suspect that there are now much better drivers than Gecko around based on the latest generation of stepper driver ICs (unless Gecko have also updated).  Maybe ask on mycncuk?

Edited By John Haine on 20/01/2020 09:24:37

Hi,

I have a Denford Orac which I converted to Mach 3 using the existing steppers but used a couple of generic type drivers. I found they were powerful enough to do anything that could be mounted in the lathe. I fitted a Smoothstepper Board and found that the Orac runs a lot smoother since then. I control the spindle with a Seimens VFD and I find that the programmed speed is correct within a couple of revs, in fact as good as the spindle on the Haas TL1 at work! I used the original index pulse and I can thread beautifully and have thread from 1/8" BSP to 30 mm x 6 trapazoidal successfully. I also have a Denford Novamill converted to Mach3 and the original steppers and drives have never run out of power or accuracy but she settings in Mach3 must be spot-on.

Hi, Andrew.

I bought the CW8060 60 volt drivers and the 60 volt power supply from CNC4You.uk.

The Ethernet Smooth Stepper I got from from Amadeal.

The Break-out Board I got from Machdrives in Australia. This is a very good board with a very stable 0 – 10 volt output to control a Siemens Micromaster 6SE Variable Frequency Drive which drives the original GEC 3 phase motor. The spindle pulses come from the original Orac and if the Mach3 settings are correct it is excellent.

I have cut a 30mm diameter x 5mm pitch (not 6mm as I said before) trapezoidal thread at 200 rpm and though it is scary to look at everything worked fine for the 150mm long shaft.

Not exactly UK based…

+1 for Zapp Automation, excellent supplier.