You will likely have to mount the bed casting on it's side and end to machine it on a Myford as you are unlikely to have the height above the cross slide to do it sitting the right way up

Once the bottom of the bed is flat which may well have to be done by hand drill the mounting holes and then screw it to a rectangular plate as that will make it easier to clamp and you can run a dti along the plate to check for square. You then need to get inventive with angle plates etc to bore the hole for the end of the cylinder liner and flycut at the same setting, then reposition to bore the main bearings which are likely to be the hardest to set up as the front mounting lug looks like it is at least 3.5" beyond the vertical ctr line of the crank. Something like these setups

Edited By JasonB on 21/05/2021 07:15:02

Edited By JasonB on 21/05/2021 07:31:33

Just felt it was the better setup for the job, having 5-6" of cutter sticking out of a boring head can start to flex a bit so the between ctrs bar keeps things parallel and you get a nice steady cut with carriage feed.

Also add to that the length of a boring head and the part which is 11" long and you can run out of head room on all 3 of my mills